Desktop Cap Press Machine

product details

Product introduction

The stroke length of the cylinder can be adjusted by the top knob, and then fixed by tightening the top screw.

Limiting bottle clamp: Position the bottle and adjust the front, back, and up and down positions through elastic screws.

Foot switch: If the foot switch is kept pressed and held firmly, the cylinder will remain in a depressed state.

Instructions for use

1-1: Connect the air supply pipe to the air pipe interface

Pressure adjustment method: Pull up the black cap and rotate it left and right to adjust the pressure

Regulating pressure 0.4MPa

After adjustment, press the black cap.

Note: The normal working pressure of the capping machine is around 0.4 MPa; If you feel that the pressure on the cover is not enough, you can increase the pressure to about 0.6 MPa appropriately; If you feel that the pressure is too high similarly, it is possible to reduce stress appropriately.

1-2: 【 Lid height 】 Adjustment method: First turn off the air source, pull down ⑥ the lid head; Place the product that has already been pressed under the ⑥ capping head, compare the height difference, and adjust the ① handwheel to ensure that the height of the ⑥ capping head is consistent with the product height during pressing, or the capping head is slightly lower than the product height; The specific height depends on the actual situation of the product and it depends..